| Introduction | Dimensions | Hydraulics | Production | Excavator | Applications |

MB-C50 S2

MB-C50 S2 crusher bucket by MB for 4~10 hydraulic excavators. Suitable for demolition, road construction, reciclying, land reclamation.
MB-C50 S2 crusher bucket

MB-C50 S2 crusher bucket

Dimensions

MB-C50 S2 crusher bucket has a total dimension of 1240 x 1000 x 770 mm and weights 750 Kg without upper plate and coupler. The front aperture of jaw is 600 x 250 mm, and the output can be regulated by means of shims between 15~70 mm.

The bucket has a loading capacity of 0.13 m3.


MB-C50 S2 バケットクラッシャー

MB-C50 S2 バケットクラッシャー

DescriptionMB-C50 S2
Lenght (mm)1240
Width (mm)1000
Height (mm)770
Weight (kg)750
Aperture width (mm)600
Aperture height (mm)250
Loading capacity (㎥)0.13

Hydraulic requirements
MB-C50 S2 hydraulic requirements

Only three hoses are necessary to operate the MB-C50 S2, IN, OUT and DRAIN.

Under specific conditions the bucket can be adapted to work also only with two hoses, without drainage. In this case the excavator maximum back-pressure at any time in the system must be lower than 10 bar.

The reccomanded excavator for the MB-C50 S2 should be equipped with hydraulic system with simple effect.

The required flow for the MB-C50 S2 is 90 l/min at 200 bar. Our tecnichians can verify the right values of flow and pressure available at your excavator with precise instrumentation (flowmeter).

DescriptionMB-C50 S2
Flow (l/min)90
Pressure (bar)200

Production

The MB-C50 S2 can reduce concrete, natural stones, bricks, glass etc., to a size between 15~70 mm.

It can produce up to 10 ㎥/h which means about 15 ton/h if we consider concrete with an average specific weight of 1.5 ton/㎥.

The real throughtput can vary depending on the input and output size of material, its humidity, the presence of soil, etc.

The best way to obtain a high throughtput (production per hour) and a low wear of parts and jaws is to sieve the material before size reduction process. In fact, demolition material contains a lot of sand, soil and dust, that doesn't need to be reduced.

Please refer to our Screener line-up for this scope.

DescriptionMB-C50 S2
ModelMB-C50 S2
Max production (m3/h)10
Max production (ton/h)15

Excavator
MB-C50 S2 excavator

To operate the MB-C50 S2 the excavator must have have hydraulic system with specifications set forth below, and enough lifting capacity and weigth to be stable during loading, processing and unloading phase. The recommended excavator weight is between 4~10 ton.

Please check the user manual of the excavator for the weight and lifting capacity, in case MB Technical Staff is happy to help you in finding out the relevant data for your excavator.

MB has successfully installed and operated the MB-C50 S2 on all main excavator's brands.


Applications

MB-C50 S2 crusher bucket has been succesfully used in applications for demolition works, road construction, recycling, excavations, mines.


MB

Contact us

Contact us by clicking on the image on the side for any information regarding the product, its applications, use and possible savings in adopting the MB technology. We sometimes have second hand buckets available to sell. Feel free to contact us if you are interested in a quote, a demonstration or need any service assistance. We will be very happy to help you.